keywords: ip pbx voip gateway gsm gateway



The forum is in read only mode.
× Questions about IX100

BIOS Setup in IPC 110

12 years 7 months ago #7635 by exkg

How can we access the BIOS setup in a IPC-110 ?

12 years 7 months ago #7637 by Joe.Yung
Hi Luciano,

You have two methods to do that.

1.Creatie a serial interface cable and connect it with your PC machine by a hyperterminal. Default baud rate is 115200.

2.Buy our accessor ACC1005(VGA interface) so that you will be able to access directly by monitor.

i] Last edited by Joe.Yung at 2011-12-5 09:46 [/i

11 years 3 months ago #8721 by tripialos
Good Day
I have an issue with the relevant board.

I am connecting my rs232 console cable but i cannot see any output from the POST procedure. When i power on the board i see nothing and after a few seconds the only thing i see is :

Reboot and Select proper Boot device
or Insert Boot Media in selected Boot device and press a key

I press enter and the message just comes back.

Any ideas?

11 years 3 months ago #8726 by Joe.Yung
Time to create page: 0.040 seconds
Powered by Kunena Forum